2002 Nissan Sentra "timing 1" Questions

...timing marks remove the no 1 spark plug or injector. Place a straight piece of wire into the hole and slowly turn the crank until the wire is pushed right to the top. At this point there will be a ...

...timing. 1 Remove the VTC valve from the vehicle. 2 Using a fused jumper wire, apply battery voltage to terminal 1, and ground to terminal 2. 3 If the valve is functioning correctly, the plunger shaft ...

...timing light to the No. 1 spark plug wire and battery. 6. Loosen the distributor hold-down bolt and adjust the ignition timing to 10 degrees BTDC for the GA16DE and 15 degrees for the SR20DE engines. ...

...timing cover. It is 1 1/2 round and about 3/4 inch with a groove in the middle where a bolt is tightened. When you remove the timing cover you will see the timing belt, the camshaft sprocket and the ...

1992 Nissan Sentra making a hard clunking noise when shifting My 1992 Sentra is making a hard clunking noise when shifting from gear 1 to 2 (auto-trans)...It doen't make any other noise when shifting ...

O2 sensor on 2006 Nissan sentra location of bank 1, circuit 1 my code p0420 2006 nissan santra 1.8 cut off why drive some time in hard to crank up when it do that

nissan sentra gxe the car shut off when stop. check engine lit . the scanner read sensor 1 bank 1 , sensor1 bank2 , i change the TPS . the car still having the problem when stop but is not all the ...

1. replace the sparkplug 2. replace your head gasket 3. check if your ignition timing is correct (timing in the distributor, camshaft, and crankshaft) if these does not solve your problem, try this: 1

2000 Sentra 1.8 will stall at times when idle or 2000 Sentra 1.8 with 157,000 miles will stall at times when in idle or driving and would be difficult to restart. While driving RPM's will go up and ...

...rotor is on the right point? check distributer cap, if the timing is off that means the points are not synchronizing the points are THE TIMING POINTS ARE 1-PULLEY 2-TIMING CHAIN