2004 Ford F150 "idle control module" Questions

...Idle Control System RPM Lower Than Expected & P0420 Catalyst Effeciency Below Threshold Bank 1 are the codes that I get. Is there a simple fix? Thanks unfortunately no ! Your best bet take it to ...

...control module is not located on the side of the distributor were i was told it was.the truck was idling and it just died noew it turns over but wont fire off any ideas on other things to check ...

...idle till cools down then same thing Probably a bad ignition coil or a bad TFI module (the ignition control module). Much testing could be done to find the faulty part, but I believe if you take the ...

...idle air control valve (IAC) control the engine idle speed and dashpot functions. The valve is located on the throttlebody . This valve allows air to bypass the throttle plate. The amount of air is ...

...2003 ford f150 when i start i have to keep foot on the gas or it will die Has the idle speed control system been scanned or a fault code test been run on the engine control module? If not do this

...pressure regulator. try throttle position sensor or map sensor or ignition control module thats mounted on the distributor.there is also a idle air control module too attached to the throttle

...idle air control too low sounds like it must have gotten wet can it be dried out or is it totaled??? 2004 f150 4.6 P0506 - Idle Air Control System RPM Lower Than Expected  Vehicles with ...

Idle control sensor, plugs, wires, distributor and distributor cap. rotor button, radiator, clutch assembly and fan what else will make it not run? Possibly the ignition control module, if there is no

...control module) If your having idle problem, cleaned the throttle body real good (just to make sure there wasn't a problem there) then do a "IAC relearn" by unhooking the battery, letting it sit for ...

are there torque specs for the throttle body & the idle air control module? its a 2001 f150 w/a 4.2l v6 no torque specs just don't over tighten