1998 Ford Taurus "water pump belt routing 98" Questions

Ad

...diagram for 98 gmc suburban sepentine belt should be diagram on top of rad cover if not start with crank and go around water pump with back side of belt if its the rite belt can only fit one ...

Ad

Question about Ford Taurus

1 Answer

Down to A/C compressor 5) Back to crank pulley 6) Forward around tensioner 7) Back glancing off of water pump 8) Back glancing off of ribbed idler 9) Up around alternator (where you started) Good luck

Ad

...ac compressor)and then water pump and then alternator.but try to put it on the alternator first before the water pump u have to try to keep it on the water pump hold it while pull back on the ...

Question about Ford Taurus

3 Answers

...5) Back to crank pulley 6) Forward around tensioner 7) Back glancing off of water pump 8) Back glancing off of ribbed idler 9) Up around alternator (where you started) Good luck! Hope this help : -

...water pump pulley because the wobbley idle pulley guides the belt half way off of the water pump as soon as i start the car. Also, the belt squeals when the car is at a stop and the A/C is running. ...

...water pump and the power steering pump, if necessary on the 3.1L engine. NOTE: For the 3.1L engine use a long 3 / 8 inch drive ratchet or breaker bar. For the 2.4L engine and 1999-00 3.1L engine, ...

Question about Ford Taurus

2 Answers

...water pump, alternator, and engine crankshaft can result.? 11 Pry the idler or generator pulley to adjust the belt to specifications. 12 Tighten the idler or generator pulley fastener. 13 Start the ...

...water pump might be spinning the wrong way. Note: If you don't have a good floor jack, you can jack up the car, place a support under the oil pan, then slowly lower the car until the engine is ...

...water pump pulley and finally to the tension pulley. Tighten the tension pulley bolt. Once installed, there must be not slack in the timing belt. The belt teeth must be in perfect alignment with the ...

Question about Ford Taurus

1 Answer

...water pump pulley. Remove the valve cover and the timing belt covers. Align the camshafts and install the camshaft alignment tool on the back of the camshafts as illustrated. Fig. 16: Align the ...

Not finding what you are looking for?
1998 Ford Taurus Logo

1,980 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Ford Taurus
1999 Ford Taurus

2,348 Questions

2001 Ford Taurus
2001 Ford Taurus

2,262 Questions

2000 Ford Taurus
2000 Ford Taurus

2,120 Questions

2002 Ford Taurus
2002 Ford Taurus

1,869 Questions

1996 Ford Taurus
1996 Ford Taurus

1,365 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...