door latch near the rear of the door tries to come up but doesn't. It will lock just fine, just won't unlock, and you have to open it with the inside handle by going thru from the passenger side. lots
...rear hatch, ive repaired a couple, the wiring breaks causing the defogger and wiper and release to stop working the wiring runs next to the latch,but start with the fuses first.good luck. the wires ...
Question about Cars & Trucks
...door latch on a 2007 chevy express cargo van. when i pull on the handle, the door stays latched. I think the latch rods seperated from the handle Can't open left rear cargo door You will need ...
...door latch I came up with an inexpensive solution - I used a thick wire to make an alternative hatch release: (here's a video I made of the repair http://youtu.be/igDuqe5pa7w). I hope this helps! ...
...door latch replacement 2003 sequoia 2003 touota sequoia rear door latch .how do you replace the latch Fig. The latch bracket shown is moved by loosening the mounting fasteners and sliding it as ...
...door latch broken how do I get the panel open if the door is shut, it is a real doozy but i have done it. you have to pry the inner panel off the door using hook tools and small, crowbar shaped tack ...
Question about Ford Explorer
...door ''rear latch switch'' location Trying to find the location of the right side power sliding door ''rear latch switch'' on a 2001 toyota sienna van. (That is the electrical micro switch not the ...
...opening it, is there a way to toggle the latch manually from inside the door ?? If I can unlock/open this door, I think that I can repair or replace the latch mechanism. pull or push linkage by ...
...door latch receiver mechanism can go bad too. The key will lock the driver side door but wont unlock the driver side door. The only way to open the door was to go to the other side or the rear driver ...
...door not open? If neither handle works, then it is the latch. There is a rod that is held to the latch with a plastic clip. It could've broke or just opened up, releasing the rod. You have to remove ...
4,510 questions posted
Usually answered in minutes!
2,307 Questions
2,248 Questions
2,302 Questions
1,513 Questions
1,369 Questions