2001 Dodge Ram 1500 Truck 2WD "high voltage tps code" Questions

Ad

...high voltage ignition on low voltage at idle. Idle surges sputers and stalls when driving. Replaceed mapp and tps with no improvment? Truck is surging at idle in park. When stalls and sputters when ...

Ad

Question about Dodge Ram 1500

1 Answer

high a voltage. Symptoms may include: Rough idle High idle Surging other symptoms may also be present A code P0123 may mean that one or more of the following has happened: TPS not mounted securely TPS

Ad

...high a voltage. Were codes deleted after this job? This is a code for TPS voltage high. The sensor voltage should never be greater than 5volts. It normally reads .5 to .8 volts at idle (closed ...

...High Voltage (Bank 2 Sensor 1) P0121 being throttle position sensor.Replace the TPS or inspect the wiring harness. P0123 Accelerator Position Sensor (APPS) Signal Voltage Too High. APPS voltage input ...

Question about Dodge Ram 1500

1 Answer

...high a voltage.Symptoms may include:-    Rough idle-    High idle-    Surging, other symptoms may also be presentA code P0123 may mean that one or more of ...

...put new tps and check engine light went off but what does a ckt high input mean This means the TPS is sending too high of a voltage back to the computer. Usually caused by a short in the ...

...voltage high if there are no vacuum and exhaust leaks, and the oxigen sensor voltage is lazy and stays low in the 1-200 mv range, replace it. The tps voltage, adjust the sensor to about 1 volt. Check ...

...voltage out of range (low and high) If you get both codes at once, then : TPS may be defective, wiring to TPS may be shorted to ground. There may be a problem in the +5V circuit powering the TPS. ...

...high voltage code. I need to know the process to check it electrically. YOU NEED A DIAGNOSTIC SCANNER THAT WILL SHOW YOU TPS SENSOR OPERATION.WITH THROTTLE CLOSE TPS SENSOR VOLTAGE OUT PUT 0 AS YOU ...

Question about Dodge Ram 1500

2 Answers

Voltage High Throttle position sensor input above the maximum acceptable voltage. Do not just go around replacing things. They are at high voltage because they are trying to over correct for something

Not finding what you are looking for?
Cars & Trucks Logo

1,568 questions posted

Ask a Question

Usually answered in minutes!

Top Dodge Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...