2001 Ford Focus "engine not turn" Questions

...tensioner, it could be loose, not belt movement. if all items are turning, not slipping, but turning at speed with engine, they have to be working or the engine would not turn, engine would not

...turn the engine. the car is a 54 plate c-max tdci auto and tiptronic manual g/box i have fully charged battery still nothing any ideas where to go next if the starter is not turning the engine, then ...

...ENGINE WILL TURN OVER IF SO ENGINE NOT SEIZED UP. IF ENGINE WONT TURN OVER MORE LIKELY ENGINE HAS SEIZED UP.IF ENGINE CAN BE TURNED USING A WRENCH CHECK BATTERY VOLTAGE SHOULD BE 12.6 VOLTS. IF ...

...turn over engine. Can be push started, and seems to run normally until engine is stopped again. No apparent drain on battery when ignition key is turned. Nothing seems to happen under hood. Engine ...

...engine at high rpm it turns on briefly .but it use to turn on sooner what do you think the problem is I would not consider this a problem unless the engine is overheating based on engine temp and ...

...turn the a/c on it puts more strain on your engine and cooling system. My taurus had a similar problem and it turned out to be the blades on the water pump were about gone from corrosion. Anti-freeze ...

...turn the engine over you will get no spark. Lets start over. You turn the key , does the engine turn over ? Does it turn over and not crank up and run? If your starter is not turning the engine, the ...

...turn the engine with a breaker bar. Then put a probe into the sparkplug hole and you should be able to feel the piston coming up in the cylinder. If the piston does not move you can start ...

...turn over, but not start. Battery seemed good, but jumped it to another car, and still wouldn't start. Then a couple of days later it started, but idled so rough that I had to shut it off. I went out ...

...turn the engine over Sounds like the timing belt as broke. The crankshaft WILL still turn when cranking the engine... the problem is that the camshaft(s) are not turning. This MAY be an INTERFERENCE ...