2001 Ford Focus "engine block heater 01" Questions

block in engine compartment. i had the same problem and i had to replace the dual zone control center check fuse No.7(10A) in junction block it is under instrument cluster ! Had a similar problem, had

...engine from cracking in case water freezes inside of it but if you have good strong anti-freeze (glycol) in your rad that shouldnt' be an issue but worse than the frost plug popping out is cracking ...

...block the radiator and cause your engine to overheat and damage the engine. The thermostat can be stuck close. If you feel the upper hose very hot and the lower hose cooler than normal, it may be a ...

...block drain on a Kubota engine V1902-B? [PDF]KUBOTA DIESEL ENGINE - Waterax waterax.com/app/uploads/2015/09/ENGINE-MANUAL-D902.pdf engine maintenance. it is KUBOTA's policy to utilize as quickly as ...

engine block does not heat up I have changed the rad, heater core, thermostat 3 times and the heater hoses and still can not get the block the heat up enough to open the thermostat. This is on a 1996 ...

...heater there is a very good chance you have an air pocket trapped within the engine.If this is the case, try to get the front of the vehicle elevated as high as possible (a small hill works and air ...

...engine compartment, bottom of the firewall, just forward of the passenger's feet. Condensation should be dripping out of that. Take it to a shop, have it put on a lift and run a big pipe cleaner in ...

...engine as you could get badly burned ,,,, locate the heater hoses going into bulkhead ,these are rubber hoses NOT STEEL,,and disconnect them both ,,,, get a garden hose and run the water in one of ...

engine I can not find the plug to plug into power to keep the glow plugs warm and it fails to start this morning due to the weather being so cold can someone help me find the plug to plug it up I have

...block of the engine, or a leaking gasket which is causing the coolant to be drawn into crankcase or combustion chamber. Pull your oil filler cap off and see if it has a foamy coating underneath or ...