1996 Ford Crown Victoria "vic sensor 1 bank" Questions

Ad

Question about Ford Crown Victoria

2 Answers

...vic. 4.6 got a o2 code.. bank 2 sensor 1.. which one is that?? left side or right side?? okay to make it simole for you......bank 1 is the bank where number 1 cyl. is located,so in your case you need ...

Ad

...Vic LS, Codes read: (p0720 output speed sensor circuit), & (p1131 lack of heated oxygen sensor bank 1 sensor 1 switch indicates lean)........Keep in mined that I just swapped engines, from a 2001 ...

Ad

Question about Ford Crown Victoria

2 Answers

...sensor 2 along with 301 cylinder 1 misfire and 304 cylinder 4 misfire. Could the 136 be caused by the misfires ? I'd like to just swap out the plugs, but, they seem tricky to get to. Or could it be ...

Question about Ford Crown Victoria

2 Answers

...Vic Police Edition. When I 1st bought it, the car was misfiring so I had the two misfiring coil packs replaced after the car broke down and wouldn't accelerate any longer. Almost 5 months later, ...

Question about Ford Crown Victoria

1 Answer

...Vic-tron--In your response to "guest dated June 2010, You said that the O2 sensor that is located in front of converter is considered "upstream and after the converter would be considered ...

sensor fuse located on a 2008 crown vic The 02 sensors are in the exhaust. In the picture you can see two 02 sensors in each bank, right and left. Before and after the cat. You trouble code may relate

Question about Ford Crown Victoria

1 Answer

...on my '94 Crown Vic, just serviced the trans, just changed my fuel filter and cleaned the MAF sensor. I have new O2 sensors, it only requires 2, I need to put them in and see if the issue goes

Question about Ford Crown Victoria

1 Answer

vic, missfire on cylinder 4 and lean mixture on bank 1 ( other side from cyl 4) replaced fuel filter and O2 sensors and coil on cyl 4 (had crack in it) all is good now. check your mass air flow sensor

Question about Ford Crown Victoria

2 Answers

air control (IAC) valve position sensor fault.59 Rear Oxygen (O2) sesnor fault.61 Transaxle control module torque reduction signal fault.62 Variable Induction control (VIC) valve position sensor fault

...sensor isn't enough... I've been going through the same thing with my Crown Vic Police Interceptor. Bank 1 and 2 together, I would be highly suspicious of the MAF. Before investing big bucks to ...

Not finding what you are looking for?
1996 Ford Crown Victoria Logo

453 questions posted

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...