1992 Ford Ranger "connect bonnet locks" Questions

...assembly. The screws located between air manifold and radiator. 4. Once the screws released, disconnect the alarm cable/socket connected to the lock assembly. 5. Try pull open the bonnet, it may ...

connect bonnet lock wont open Once the grille is removed it is a tight squeeze but you can get in a 10mm ratchet spanner and remove the bolts from the back of the catch mechanism, be careful once they

ford focus 56year key wont open bonnet stripped out grill the lock cable and plastic connection to the bonnet catch is there in front of me but i dont know how to disconnect the plastic connection or ...

...should be a cable release that should open the trunk. then, you will need to check all the linkage connected to the "key tumbler" and make sure something did not come

...Fiesta 1.6 rsi 2002. The bonnet wont open the cable and lever in the car are fine but the cable connecting to the lock that holds the bonnet has either snapped or come out Clinton Go to a

This is the POSITIVE power terminal. Connect your power pack RED / POSITIVE cable here and then connect your BLACK / NEGATIVE cable to a good earth point, like the engine mount bolt, bonnet lock, etc.

...connect the jump leads and then unlock the doors (the bonnet switch for the alarm I think is the same one for the under bonnet light so you might have to tape it down whilst the bonnet is open, just ...

...connect it back again. If your car is old, the doors have to be adjusted sometimes. There is a bump limiter on some cars when the bonnet is closed, so you might need to adjust it so that the bonnet ...

...bonnet to get to battery? sovereign Jack up vehicle and jump power of the starter. Ed (above) means jack up the front of the car and connect the + jump lead to the big cable lug on the starter motor, ...

...the car alarm goes off. hi just connect the battery close the bonnet and do what you normally do to lock and set the alarm it should reset itself it normall for alarms to do these things ...