...ball joint. i take off everything. i just wonder and can i take off both solid axle shaft so i can take off the ball joint The steering knuckle has to be removed so you can use a ball-joint press to ...
1998 Ford Ranger 4x4 How do you replace the ball joints rent a ball joint tool from your local auto store, they can be rough to install.
ball joint on a 2001 ford ranger, xlt, 4x4 v6 4.0 liter You will need to replace the control arm with the ball joint since it is not sold separately. If one is found it will be a foreign made piece of
...the front tires on a 2000 4x4 ranger lean in at the top.I have noticed it on most rangers. already replaced ball joints. It needs a front end alignment,they will correct this problem on the
how do you replace ball joints on 1994 ford ranger 4x4? Want a diagram please!!! Look on You Tube,you will find anything you want on Video from repair shops
...ball joint replacement question: Does the spindle need to be removed to remove the drive shaft? Any tips on spindle removal? All bearings, spacers etc are off and spindle nuts have been remove, but ...
4x4 and i have replaced all the ball joints and it still makes a poping noise when i stop and take off again like a bushiung is bad what bushiung could it be control arm bushings that are worn do make
...4x4. Needs front lower and upper ball joints. To order them they ask for the spindle spline count. No tag is on the front drive. Vin number will not give the count. Where can you get it with out ...
...THE FRONT HUB/AXLE ASSEMBLY APART? hello,yes you do have to take the hub off to replace the ball joint with the ball joint being on the back side of the hub. hope this helps and please rate
...ball joint set bolts, cotter pin and nut from tie rod, tie rod from ball joint bracket, ball joint from lower control arm, 4 lower ball joint set bolts, ball joint from suspension. Install is reverse ...
1,000 questions posted
Usually answered in minutes!
645 Questions
573 Questions
562 Questions
558 Questions
477 Questions