1996 Dodge Neon "dash lights headlights turned" Questions

...dash lights or tail lights. does have headlights and turn signals. the brake lights work also. the fuses are good. then the problem lies near the dash because dash,tail,and license plate lights work ...

dash lights and the tail lights dont come on, is this a fuse or is the headlight switch bad? Okay first check your fuses ensure I turn on the headlights and the... they are good. Otherwise most lights

...stays on when the headlights are on the left arrow on the dash stays lit up and the blinker wont work sounds like you have water in youre light socket. or the wrong bulb is installed.or a blown

...lights will not turn off and a burning type smell dash. only way turn turn them off is to remove the fuse after I turn the car off. the daytime runnling light module is in the dash under cigarette ...

...dash lights come on A number of reasons that dash lights will not come on. Let us start with the first. Do the parking lights come on on the outside of the vehicle when turning the switch on? If so, ...

dash for a gauge dimmer control switch. It is probably turned all the way up and in the clicked on position. Its usually located on the drivers side near the headlight switch if your headlights aren't

headlights on and the right turn signal on the dash is slightly light weird stuff like thi is almost always a bad ground. I would check the ground for the wiper motor first, then headlamps. last check

...dash warning lights should turn off at this key position (most cars). If you're not sure, turn on the headlights. When you try to start the car, the lights should either dim (a lot) or turn off ...

...dash lights and headlights, if there are no headlights or park lights and no dash lights then theres a bad connection, start at the battery remove the terminals and clean posts then follow the groung ...

...headlights smoke starts to come out the dash you've got a short... obviously you better get it checked out. You have bare wires in your dash follow them to the burnt area and replace the bare wires ...