1996 Dodge Neon "cam sensor" Questions

...sensor 0344 cam position sensor intermittent 0340 cam position sensor failure I would replace the cam position sensor from the codes you provided. The knock sensor would most likely be related to the ...

...sensor,cam sensor,pcm,wired cam and crank sensor direct to pcm,replaced coil, plugs and wiresand air intake temp sensor...also replaced plug ends to crank and cam sensors sounds ike it could be the ...

...cam shaft sensor is unplugged i have check the timing over and over, replaced the cam sensor and crank sensor, replace the wiring harness and check the cam shaft magnet! And i have checked the cam ...

Cam sensor causing other probelems I have a 2005 dodge neon. Its over 100,000 miles now. The engine light has been coming on. Some days it drives fine.. Other days it jerks/sputters when i try to go ...

...cam sensor, bought a new part and bolted it up, i still have the code 0344, misfire detected... also new plugs and wires. any alignment required for sensor? i removed the old one and bolted new one.. ...

cam sensor and computer put in both used. Shop did not put a wiring harness for the cam sensor. New spark plugs,wires, and coil pack. Car will start run gets warmed up and stalls, but not all the time

...cam sensor on my 2000 neon, check enfine light still comes on, my code reader still states it the cam sensor, could it be the wires into the sensor? If you are getting a cam sensor code, it is not ...

...the cam and crank sensors, what can be causing this? V/R wilbecraft Shake or gentle tug on the wiring harness and try starting the engine! I found that my problem was with the cam sensor wiring ...

...cam sensor, or the crankshaft sensor? Or is there another possibility? P1390 means cam/crank not in time. Probably slipped a tooth on the cam belt (Installed wrong most likely, easy to do) or, just a ...

...cam sensor connected. what's wrong with this picture? i unplug the camshaft sensor, crank the car and it started so i check for codes, came out with p0340, so i plugged it back now i gets no codes, ...