1992 Buick LeSabre "crank sensor wiring" Questions

Ad

Question about Buick LeSabre

1 Answer

...sensor car crank and runs good then when i let is run in one place it start acting like its over flood with gas but its not someone said its the crank sensor cause when i try to start it back up it ...

Ad

Question about Buick LeSabre

1 Answer

...crank sensor??? Hello: Yes, The crank sensor is behind the crank shaft pulley. Check the wiring where it leaves the sensor and goes up near the alternator. On this year car its possible a small rock ...

Ad

Question about Buick LeSabre

1 Answer

crank sensor IDK and am frustrated 3.8 litre engines have wiring issue to the crank and cam sensors the insulation breaks down on heavy oil soaked wiring thus not protecting the wires from shorting to

Question about Buick LeSabre

9 Answers

...crank sensor fixed the problem and was $30.00 from Buick. When driving 95 buick lasabre custom it shut off so i pull over and it cranks back up. about 10min driving or less it repeat it self. i have ...

Question about Buick LeSabre

1 Answer

sensor, crank position sensor and cam position sensor. Had the electronic ignition module tested. Tested fine. Still no spark. Fuses in interior fuse block test good. 1. Monitor the 5v reference, Gray

...take it to a shop at this time thank you those wires are probably going down to the crank sensor if that sensor fails then the car will not start so fix the wiring and try replacing the crank

Question about Buick LeSabre

1 Answer

...crank sensor. wut should i do next? the error on the scan reader is 3000 missfires & 1 error in cam/crank sensor Coil pack is bad for that cylinder,I hope that help you,I just had one in the shop ...

92 buick lesabre wont start just replaced water pump and belt water pump was almost destroyed which caused belt to come apart Crank sensor, crank sensor wires. Check for damage.

Question about Buick LeSabre

1 Answer

crank sensor but it still wont start. cranks over ok. no spark. the ignition module has been replaced thats weird mmmm make sure than you have power going to the black and pink wire or pink with black

its dangerous. Crank sensor? Wire going down to crank sensor has bare spot, bumps against engine block and ECM sees problem and shuts down you can restart right away, because wire goes away from block

Not finding what you are looking for?
1992 Buick LeSabre Logo

1,071 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2000 Buick LeSabre
2000 Buick LeSabre

1,731 Questions

1997 Buick LeSabre
1997 Buick LeSabre

1,603 Questions

1995 Buick LeSabre
1995 Buick LeSabre

1,084 Questions

1994 Buick LeSabre
1994 Buick LeSabre

904 Questions

1998 Buick LeSabre
1998 Buick LeSabre

897 Questions

Top Buick Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...