1990 Buick Riviera "signal loss 11" Questions

...loss of the timing belt. If no reference signal is seen during cranking after a battery disconnect, code 11 will remain. This is a helpful indicator in a no-start condition.Hope this helps and just ...

...loss of the timing belt. If no reference signal is seen during cranking after a battery disconnect, code 11 will remain. This is a helpful indicator in a no-start condition.? (Chrysler did sometimes ...

signal detected during cranking (bad Hall effect) OR timing belt skipped one or more teeth; OR loss of either camshaft or crankshaft position sensor. Can cause the engine to stop working entirely with

...loss of either camshaft or crankshaft position sensor. check connections to both sensors. also look for any damage to the wires connected to each sensor. either sensor will set off a signal to pcm of ...

or more from initial learned value, Intermittent loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking for dodge odb readout. Hope this helps

...loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking 12 Direct battery input to PCM was disconnected within the last 50 key-on cycles 13 No ...

...loss-of-brake-pedal-then-all.html----------How to replace Parking, turn, and Brake Lights on car? ...

signal detected during cranking (bad Hall effect) OR timing belt skipped one or more teeth; OR loss of either camshaft or crankshaft position sensor. Can cause the engine to stop working entirely with

...signal on the fuel injection control wire from ICM to ECM with ignition on and no start condition when it should be .08 volts and 6 volts running. Only fault code on cars' OBD, b334c loss ...

...loss of either camshaft or crankshaft position sensor, No crank reference signal detected during engine cranking. 13 - No change in MAP from start to run. 24 - Throttle Position sensor out of range. ...