1999 Chevrolet Lumina "put 2 batterys 99 chevy" Questions

Ad

...put 2 batterys in my 99 chevy cavalier i added a stereo system and my lights dim badly Yes, but make sure you connect them in series. If you do them in series, you will fry everything with 24 volts, ...

Ad

...put it back together I through the truck out of time by putting the distributor in a tooth off on the gears, so I adjusted it back into time, but now it is still giving me trouble! First it said that ...

Ad

...2 wheel drive from 4 wheel hi i put my 99 chevy s-10 blazer from 2 hi to 4 low this morning to get out due to bad weather, when i got to the highway i put blazer in neutral and pushed 2 hi button and ...

put it back together an now the anti theft kicked in an the car will only run for like 2 seconds an the theft light just stays on it dont blink at all i have tryed the 10 min test plus the 30 min test

...2 or 3 bolts holding it take the bolts out turn on your truck and remove it like you would if it was a cap in the inside should spin if doesent then thats another problem it wouldn't be your mounting ...

...put new vacuum switch in transfercase and vacuum accuator under the battery. Also a new dash push button switch. Problem is the dash switch lights up when I turn the key on or start it, but then all ...

...2.4L, it died on the road while my wife was driving. Some numbnut tried to jumpstart it and hook up the cables wrong... So far I have replaced the bettery, starter, ignition switch, and engine ...

...2 screws under where handle is located. A Phillips screw driver removes the door handle cover. Pull on door panel to pop off, whole process takes under 5 minutes. If motor works and no power to motor ...

Question about Chevrolet Lumina

7 Answers

...put them back in or let them touch "ground" during the test. LAST: 2. The wire near the dome assembly may be corroded. Remove the dome assembly and let it hang out. The light should go OUT when all ...

2 kOhm and a 1 kOhm resistor in parallel. Don?t make this as hard as I did. Bring a calculator, or at least a pen. Buy the resistors and a 40W soldering iron. Here?s the action: twist the leads on the

Not finding what you are looking for?
1999 Chevrolet Lumina Logo

927 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

Top Chevrolet Experts

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...