2005 Chevrolet Silverado 2500HD 2WD "replace blower motor resistor" Questions

Ad

Question about Chevrolet Silverado 2500HD

1 Answer

replace blower control resistor mounted under the passenger side of dash. also inspect the connector that plugs into the resistor for any problems. the resistor is mounted next to the blower motor and

Ad

Question about Chevrolet Silverado 2500HD

3 Answers

...replace the Blower Module assy. (electronic resistor) make sure the harness connectors are good. Sounds like a bad blower motor resistor. It is located under the dash on the drivers side near the ...

Ad

Question about Chevrolet Silverado 2500HD

2 Answers

fan motor doesn't work in position 1 or 2 but works in3,4,5 Probably the blower motor resistor pack has gone out. You need to replace the blower motor resister.

Question about Chevrolet Silverado 2500HD

3 Answers

blower motor has a replaceable resister that is most likley the problem . Replace both the fan and the resistor, that should cure your problem I had the same problem. It wasn't the resistor or the fan

Question about Chevrolet Silverado 2500HD

2 Answers

...blower motor resistor. It's mounted next to the blower motor under the dash. Also check the 7 wire plug going to it, GM had a problem with that plug, and the wiring getting hot and melting. The plug ...

Question about Chevrolet Silverado 2500HD

1 Answer

ac\heater blower switch only works on higher settings The blower motor resistor is bad.Replace this and should correct your issue.

Question about Chevrolet Silverado 2500HD

1 Answer

...blower motor you will see a flat plug into a piece bolted in air box this is the resistor. the wires are bad about burning up also un plug and check that if so gm sells a replacement plug. sometimes ...

Question about Chevrolet Silverado 2500HD

1 Answer

...power. If it is replace the blower motor. If your heater seems to work on high but not the other 4 settings. replace the blower motor resistor and pigtail (same general location as blower

Question about Chevrolet Silverado 2500HD

1 Answer

blower motor. Unplug the resistor and make sure the pins in the connector are not burnt. If they are you will need to replace the resistor and the connector. Both should be available at any good parts

Not finding what you are looking for?
Cars & Trucks Logo

249 questions posted

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...