ABS It seems like my ABS is kicking on when it's not needed. At low speed, almost a complete stop the brake pedal stiffens up and that ABS grind sound is heard. If I let off and re apply the brake I ...
Question about Chevrolet Avalanche
Where is the abs control module located on a 02 chevy avalanche ? The abs motor runs constantly when the engine is turned off. Had to remove the abs fuse to make stop running. THE EBCM IS BAD this is ...
what do i do once i have the codes for an ABS problem? ABS light on but brakes are working fine. I got the codes but not sure what to do next. Help please! Are both the the abs light and the brake ...
the abs brake sensor stays running even when I the abs brake sensor stays running even when I turn the ignition switch off. The ABS modual has gone bad. You can pull the ABS maxi fues under the hood ...
Question about Chevrolet Avalanche
My brakes locked up on 2004 Chevy Avalanche, I can not locate ABS module I have looked up ABS module location. Everything says it's on frame relative to bottom of driver front seat. My gas tank ...
Abs and brake lights are on and annoying bell sound Replaced brakes but why are abs and brake lights still on and bell sound won't go away make sure ABS SNSORS ARE SET PROPERLY AGAINST TONE WHEEL, air
abs and brake lights comes on the abs and brake light comes on after I drive a little ways. the brakes work fine but what could be wrong with the abs system. will the truck pass inspection if this ...
Question about Chevrolet Avalanche
the brake and ABS comes on while driving for awhile then turns off then comes back on...the code reading from general code reader says, "low oxygen the brake and ABS comes on for awhile then turns off
Does a 03 chevy abs module have a bleeder on it antilock braking systems have sensors and if the abs light is on the sensor is 99% at fault all brake systems whether you have a disk or drum set up ...
abs light stay on aftercomplete brake job front and back the abs sensor is reading low prime pressure,sometimes you may have disconnect battery for about 3 to 5 min then reconnect battery it should ...
902 questions posted
Usually answered in minutes!
471 Questions
445 Questions
356 Questions
231 Questions
97 Questions