1996 Chevrolet S-10 Pickup "s10 wiper" Questions

...wiper motor in chev s10 Is it difficult to change wiper motor in 1998 chev s10? It's not bad. They make a special tool to remove the motor from the arm assembly, but with a little determination I was ...

...S10 windshild wipers how do i get my windshild wiper arm off of my 1984 chevy S10? at the arm remove the cap on end and their is a nut remove it 10 mm / Please rate my response thank you very ...

wiper motor circuit board first. on my 94 s10 the wipers either worked when they wanted to and now they dont work at all. just either replace the circuit board yourself ($19.95 on ebay) or replace the

...s10 Pickup the wipers stopped working and i switched out the wiper motor with another one.it has pulse on the switch the washer works fine with both motors.just the motor wont work what else to try? ...

...s10 blazer wipers run on there own and the engine misses,most of the time they happen when there is a strain on the engine. You are gonna Have too replace the Wiper Motor. There are Numerous Recalls ...

...S10 wipers will not work. fuse is good, can't find any wiring breaks, wipers will not work. Is there another fuse block? Thanks use a 12 volt tester an check the wires at the motor if you have power ...

...removing wiper switch on 1983 chevy s-10 The Chevy s10 had a recall on the wiper motors for a few years...I need to know if your are changing the complete motor or just the motor internal

s10's windshield wiper, not the arm but just the wiper. cant find a release switch and am thinking i need to force it off Use a small screwdriverslide it between the plastic of the wiper blade and the

...S10 wiper arms How do i get my windshild wiper arm off of my 1984 chevy S10? I cant figure it out No Problem! Look down on the Bottom of the Wiper Arm, wher it attaches and Swivels. There is a Small ...

...wiper arms Have 87 Chevy S10. How do you remove the windshield wiper arms? Need to remove the bolt on the backside of the wiper motor to replace it but cant get in the firewall. Need to remove the ...