...installed a new TAC gas pedal assy, this did not cure it so they took it off next was a new ECM and reprogram car is still broke. Another local shop has it now and they have not found anything ...
...new plugs and wires,spout circut pin,ignition control modual,computer, I am told that the crank sensor in built into the distributor in the stator assembly. What is left to do ? At this time I am ...
Question about Mercury Cars & Trucks
...crank? Yes GO to A7 . No INSTALL a new starter motor. TEST the system for normal operation. A7 CHECK START INPUT TO THE STARTER MOTOR Measure the voltage at the starter motor solenoid S connector ...
...crank condition due to an open circuit in the starter relay to starter motor circuit at the starter motor connection. ACTION Follow the Service Procedure steps to correct the condition. SERVICE ...
...new pcm to ???? Was it programmed ? Dealer ! checked senors 5 an 7 are the ones that ive found to be the promblem ?????????? What are sensors 5 & 7 ? 2000 PCED On Board Diagnostics II SECTION 5: ...
...new Engine Control Module (ECM) or Powertrain Control Module (PCM) is programmed with the latest version of the vehicle program for the specific model and does not need to be "Programmed" using the ...
Question about Pontiac Sunfire
...installed rotate the crankshaft over 2 revolutions and make sure is rotates freely, and your timing marks are aligned perfectly if not the engine will not run properly, tension the belt as needed. ...
Question about Pontiac Sunfire
installed right. Meaning that nothing turned while replacing it. Secondly, after replacing the sensor make sure there is a signal(power) from the ignition source.(ie, distributor or coil pack), third,
...installed 2 yrs ago and has 100k miles. Engine light is on codes were evaluated. Someone said the computer??? Could it be a sensor? What else could be the problem help!! Hi Nichelle, Take the vehicle ...
1,011 questions posted
Usually answered in minutes!
987 Questions
731 Questions
699 Questions
696 Questions
688 Questions