...wiper arm, then remove plastic cowling, the remove plastic cover over motor, then u will see tab bend it back up and u will be fixed. mark wiper arm position on shaft so you assemble in the same ...
Question about Pontiac Grand Prix
wipers stop in vertical position instead of horizontal. What do I need to replace or repair? I tried repositioning the arms but that didn't work. The will position correctly on intermittent but when I
...wiper arm Wiper arm Wiper arm mounting nut To Install: Install or connect the following: Secure the wiper arm with the nut. Tighten to: 17 ft-lb (23 Nm) Nut cover Rear To Remove: Put the wiper arm in ...
have a better chance to complete repair. Some cars to access the arm the wiper motor must be disconnected and pulled out slightly then move wiper over and reattache pin arm into lever hole nstall clip
...wiper arm on the left side doesnt move. but the right side wiper arm does question how do i repair it thank you take both wipers arms off carefully and remove grill under the arms .I think there is 6 ...
Question about Cars & Trucks
...wiper mounting arm and pivot shaft. Remove the access cover from the dash panel. Remove the mounting arm and pivot shaft retaining clip. Disconnect the windshield wiper mounting arm and pivot shaft ...
...WIPER ARM LINKAGE COULD BE BINDING.REMOVE WIPER ARM TO SEE IF WIPER MOTOR OPERATE SLOWLY.IF YES CHECK TO MAKE SURE WIPER MOTOR GETTING GOOD GROUND CONNECTIONS BY CHECKING MOVING WIRES .IF WIPER MOTOR ...
...wiper arms. There will be a cover concealing a nut on each arm. Check and make sure the nuts are tight. If tight, suspect wiper transmission disconnected from wiper motor assembly and cowling will ...
Question about Pontiac Grand Prix
i have 1995 DODGE INTREPID, THE WIPER motor is working but the arms are not moving ,how do i repair it i am trying to get info into repairing the wipers on my car ,the wiper motor runs when u turn on ...
...wiper arm is out of sync it means that arm has come loose. To repair it take that arm off and activate the wiper to get it into park position. then re- mount the bad arm in the park position, making ...
1,045 questions posted
Usually answered in minutes!
1,496 Questions
1,236 Questions
1,211 Questions
1,043 Questions
1,014 Questions