...side of the ignition coil, and then that wire will run over from the ignition coil to the ignition module inside of the distributor, and if there is battery voltage there at the ignition module,
...this is on a 98 2500 4x4 with 5.7 engine and auto tranny CHECK FUSE GOING TO IGNITION COIL AND MODULE. In the bottom of your distributor underneath the breaker less plate you will see a module ...
...through the "Pos" (+) or positive side of the ignition coil and over to the distributor ignition module, dis-connect the wire connector from the ignition module and if battery voltage is not ...
...generator were swapped out with a 1983 350 V8 and 12 vlt alternator. The new electronic ignition module was burned out by the mechanic during installation. the second distributor seemed to go in
transmission wont shift to second gear did a do something wrong by putting in ignition module and vacuum advance and a transmission module. DON'T KNOW WHAT YEAR YOU HAVE BUT THE TRANSMISSION MODULE ...
Control module where is the control module located in a 1997 chevy silverado one ton truck? Which control module? Ignition control? Engine control? What engine?
wheres the ignition module located want to remove ignition module The ignition module is inside the distributor.
Location for a lighting control module in 2005 silverado 1500 there is not a lighting control module on the 2005, the lights are controlled by the body control module and it is located on the left ...
Removing ignition module on 1996 chevy 5.0 vortec Remove the distributor cap then the rotor and then remove the wire connectors hook to the module then remove the 2 screws that mount it to the ...
...the same problem. Couldn't figure it out. Took it to the dealer, and it was a engine disable type module. There is a sensor in the ignition switch that "sees" the key (connected to this module),
1,105 questions posted
Usually answered in minutes!
878 Questions
795 Questions
575 Questions
561 Questions
414 Questions