1997 Chevrolet K1500 "engine problems vortec" Questions

...vortec engine. the problem is a bad cam gear, can i swap the motor from a 98 chevy half ton with a vortec motor with out changing anything 1996-1999 were the same engines so it should be fairly easy ...

...problems, due to the year your Chevy is. If your Chevy was a 1985 then you could go with the carb system but with being the newer OBD11 system, your going to have an off road only vehicle with that ...

...engine uses 1 injector and poppet assemblly per cylinder you could have a faulty one.If spark and fuel delivery are both ok,and the miss is there all the time you could have internal engine

...chevrolet 1500 vortec 5.0 engine Check all grounds. Give a good looking over under the hood and assure that everything is grounded nice and tight. I just read something about this in the last

Vortec 350 ( which, I assume you have) is the fuel injection spider. The spider assembly also contains a fuel pressure regulator if faulty can allow too much fuel to pass through the injectors fouling

...vortec engine I know this may sound crazy, but I had the same problem on mine.. But check your fuses.. I believe it's ECM 2 .. that fuse also runs the fuel pump...I really dont know how its tied into ...

...vortec 5.0 litre silverado engine Well code 300 is for a random cylinder miss, and code 507 is for a problem with the idle air control valve. The computer controls idle speed by regulating the amount ...

5.7 vortec Problem is engine revs high when punching on gas at 60mph to pass someone on highway and truck does not accelerate just the engine revs at a higher rpm. Any Ideas?? transmission is slipping

...engine harness computer and a complete motor which i heard run and drive no problems in that truck.compression is good idles good give it gas shakes and no powerplease help How much fuel pressure do ...

...vortec motors. Most of them require a minimum of 55psi at the rail for the engine to start properly. I worked at a GM dealer and I remember it being a common problem. Change your filter on a regular ...