1995 Chevrolet Corsica "spark coil" Questions

...coil packs that send spark to the plugs. 1 covers 2&3 the other covers 1&4. the most likely problem would be a bad coil. I have had to change them on Corsicas and Berettas. If this persists. ...

...spark is usually a sign of a faulty coil, but you have two. So if the coils are not the problem, it could be not enough voltage to the coils or something else. The coil fires when the ground ...

...ENGINE HAS 3 IGNITION COILS.EACH COIL CONTROLS 2 SPARK PLUGS.TRACE THE WIRES FROM THE BAD SPUGS BACK TO THE COILS .IF THEY ARE THE SAME COIL THEN U HAVE A BAD ONE OR CONTROL MODULE(UNDER

i have a 91 chevy corsica no spark on crank replaced coils wires and plugs still no spark brian no spark on crank replaced coils wires and plugs still no spar run the fault codes and check for ...

spark from the coil pack's. Take a long "Phillips Screw Driver" Push it into the end of the "Spark Plug Wire" Have some one hold the screw driver close to something medal on the engine. NOTE: Hold the

...coil is installed properly it happen to me I replaced spark plugs on my own blazer and service engine light came on #1 cilynder was not working so I did took the coil of again and make sure it was ok ...

how can I change the spark plugs and wire how do I know if the coils are bad LT 4 cylinder 2.2 liter intake manifold gasket may be bad,if the coils were bad you would get no spark and no fire i doubt ...

...coil housing and install the attaching bolts/screws. Tighten the attaching bolts/screws to 35 inch lbs. (4 Nm). Install the spark plug boots and retainers on the ignition assembly housing secondary ...

leads for the sparks may have bad control module or fuelpump, need to check for spark and fuel ,remove a plug wire at coil and have someone crank engine watch for sprak coming out of coil,start there

...coil.if you have no spark at the plugs then the coils need to be checked for resistance both primary and secondary.you say the car won`t start so i`m guessing their is no spark.if the coils check ok ...