2002 GMC Sierra C/K1500 "top dead center 1997" Questions

...Top Dead Center Sensor 1 - Top Dead Center Sensor 1 harness is open or shorted - Top Dead Center Sensor 1 circuit poor electrical connection Read more: ...

...top dead center mark on crankshaft for #1 on 1997 chevy 3500 5.7L vortec engine? have code P1351 I've always taken the # 1 spark plug out & with a second person hand turning engine, place your ...

TOP-DEAD-CENTER, ON THE COMPRESSION STROKE, NOT EXHAUST STROKE, IF YOU REMOVE THE VALVE COVER DRIVERSIDE IF V8, YOU CAN SEE #1 ROCKER ARMS. WHEN ROTATING THE ENGINE, MANUALLY W/WRENCH, BFW, BIG-FU-KIN

top dead center an easy way to get 1 at top dead center is to put a screw driver into the spark plug hole of number one the put a wrench an the crank shaft pully and slowly turn the motor over. i hope

...cam pullie on top and crank top dead center.does the oil pump gear haft to go straght up too.and one more thing when we get the belt on it keeps tring to roll offneed help bad.Can anybody help

top dead center. This "static" timing is all that matters and the computer will be able to control the timing as long as the ignition rotor is in that position when the engine is at top dead center. 1

...the cap You need to pull out the # 1 cylinder spark plug and turn over engine until the #1 piston is at top dead center. . Then line up the rotor with the #1 plug wire position on the distrubutor

...engine you need turn motor over until cylinder one is at TDC(top dead center) on the Compression stroke then install distributor so rotor is pointing at the number 1 cylinder post on distributor ...

...head off and lined up timing marks up,gas knocks under load. Computer check said throttle posision sensor needed replaced did that 4 DEGREES BEFORE TOP DEAD CENTER UNLESS SPESSIFIED ON TAG UNDER ...

top dead center and then when looking at the gears where your timing chain goes look for a dot on your engion near the small gear and align the dot with the dot on the small gear. you will have to put