1993 GMC Sierra "tighten 4 wheel drive cable" Questions

...4 Take the black lead of the volt meter and touch the negative battery terminal wire. Take the red lead of volt meter and slide the tip into the terminal plug you just disconnected from the shift ...

...4. Remove the ignition switch mounting bolts (usually 5/16 but I have also seen 11/32 and 3/8 size bolt heads used) 5. Remove the ignition switch by lifting straight up from the column to dis-engage ...

...4 bolts, then separate the hub unit from the brake rotor To install: Assemble the disc to the hub unit and tighten the bolts to 40 ft. lbs. (55 Nm). When installing the hub to the knuckle, use new ...

...Tighten the terminal nut to 80-97 inch lbs. (9-11 Nm). Install the exhaust system Y-pipe. Install the passenger side outer tie rod end to the spindle.See . Install the passenger side fender well ...

...4). To Install : Install the timing belt in a counterclockwise direction starting at the crankshaft. Remove the drill bit to unlock the timing belt tensioner. Rotate the crankshaft two complete turns ...

4 cyl 2 wheel drive pick-up e Removal & Installation 2-Wheel Drive - 2.2L Engine Remove or disconnect the following: Negative battery cable Front exhaust pipe, if necessary for access Starter heat

...4 Remove the two screws holding each cruise control switch (there are two switches, one on each side of the steering wheel) with a Torx screwdriver turned in a counterclockwise direction. Lift up on ...

...4 Pull up your parking brake handle up to two clicks or notches. Tighten your adjuster nut until you feel a slight resistance on your rear wheels whenever you spin them.5 Release your parking brake ...

...tighten. Reconnect the power steering hoses. Fig. 4: Install a new O-ring gasket on the hose fitting Use a new O-ring when reinstalling the power steering pressure hose. Reinstall the drive belt. ...

...4 wheel drive on a 2002 trailblazer will not engage, replaced the actuator changed the actuator, checked the fuses we had this same problem n a Sonoma pu.we had to hook up a manual control on the ...