...fluid by turning the engine on, rev it up to about 1500 rpm's, and turn the wheel left but not to stopping point and right but not to stopping point. Do this a few times and you should see the air ...
excessive brake pedal travel brake pedal goes almost to the floor before stopping, tried bleeding brakes at the callipers with no difference. Check the rear brakes are not leaking, or have air in the ...
...bleeding In excess of 20x) in a rotation from MC to RR,LR,FR,FL, I get a great brake peddle until I turn the car on. Car will stop but not before the pedal goes all the way down and the brake light ...
excessive hard braking can cause that also) I would check out your rear brakes well and bleed them off to see if that stops the problem. You can clear the code by removing the fuse for 10 seconds then
...stop well. If the pedal travel is excessive, bleed the brake system first. If its still excessive, its most likely the master cylinder, not the booster (booster will make the pedal hard). Have you ...
...excessive pressure to work The brake peddle only works the first time depressed if you try and push again on the peddle you have to push really hard and then it doesn't stop very quickly.After idling ...
Question about Cars & Trucks
...then has been softer and traveled further than ever. and now the pedal goes to the floor and barely stops was this something they did during the brake job has had excessive brake dust on the front ...
Question about Mazda Cars & Trucks
when cold . When you shut off a fully warmed up engine, the temp rises as all water circulation has stopped. This extra high temp can cause electronic parts to fail which then work again as they cool.
stop here. If pedal still feels spongy or clutch does not fully disengage, excessive air is still trapped within the system, most likely at the master cylinder. 10. Top off brake master cylinder fluid
...excessive fluid loss. Position the disconnected lines in a raised position to help prevent leakage. Remove the pump belt. Loosen the retaining bolts and any braces, then remove the pump assembly. To ...
358 questions posted
Usually answered in minutes!
987 Questions
847 Questions
676 Questions
601 Questions
604 Questions