1992 GMC Sierra "replace ignition switch" Questions

...replace the ignition switch in a 1997 GMC Sierra Truck ? take off the cover on the top and bottom of the steering column just behind the wheel. pop the tilt lever out simply just by grabbing it and ...

ignition switch for 1998 gmc pickup >>>>FIRST disable the air bag system You'll need to remove the upper and lower steering column covers. Also all the trim under the drivers side, kneee bolster, etc.

...ignition switch wiring harnes, could it be the wiring harness(ignition),can jumper red wire and pink wire on ignition conn. block and truck will start You need to take that to a tech, problems like ...

...replace ignition key in 1997 gmc sierra 2500,,tack and speedo don't work but all other gauges work for the ignition key you have to take off the two plastic covers on the steering column. (three torx ...

...ignition 3 voltage circuit of the transfer case select switch for an open, a high resistance, or a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems. Did you complete the ...

...replace an ignition lock switch on a 98 gmc sierra i afraid if i try to replace the switch the air bad is going to go off disconnect battery positive and negative to prevent air bag deployment ...

...replace the ignition switch, then also do the cylinder at the same time. With all things described, sure sounds like the ignition switch.P.S. The locks may be related to the ignition switch ...

...ignition switch. I have to play with it for alittle than it will work getting worse Replace the switch.. Replace it It will only get worse I replaced the whole Colum but there is a switch that gets ...

...ignition switch and even replaced the key/cylinder b/c the ignition switch sometimes locked up. The steering column is loose, dont know if that matters. Try adjusting the shift cable or replacing the ...

...ignition out and replace it YOUR TRUCK HAS WHAT IS CALLED A VATS KEY, SO YOU WILL HAVE TO HAVE THE KEY PROGRAMMED TO THE TRUCK ,EVEN AFTER YOU REPLACE THE SWITCH,YOU WILL PROBABLY NEED THE VIN # TO ...