1992 GMC Sierra "knock sensor" Questions

knock sensor electrical connectors. Remove the knock sensors.INSTALLATION PROCEDURE NOTE: Refer to Fastener Notice in Service PrecautionsInstall the knock sensors. Tighten Tighten the sensor to 20 N.m

knock sensor 1 bank 1 on a GMC Sierra 1999? I went to Autozone and they stated that the service engine light is on due to that the knock sensor 1 bank 1 needs to be replaced. This is the 3rd time this

...knock sensor.PCM supply 5V or 12Volts then if there is engine noise resistor raise and voltage drop.With scanner read knock sensor data while engine running you should see advance timing going down ...

i need the location of the knock sensors on a 2002 gmc 6.0 engine and any gaskets or other parts that may need replaced in the repair. The knock sensors are under the intake plenum ( the plastic part

knock sensor? Timing should be set by the PCM. So you cant adjust the timing. However if you have a faulty knock sensor the PCM cant tell the proper time to fire. The knock sensor picks up on ignition

...knock sensor a 1993 gmc sierra where do i find a knock sensor on a 1993 gmc sierra Should be on the right side of the engine by the starter.Has a 1 wire connector.It does not go into the cooling ...

...the motor i put in has two knock sensers the old one had 1 Looks like the wire from the sensor to the module is dark blue.You can find the engine diagram on autozone's website under repair

...knock sensor on 2004 gmc sierra1500 4.8 litre remove the intake manifold ,remove radiator ,remove radiator intake and outake housing, remove fan ,remove all belts: power steering, alternator and if ...

...knock sensor) he cleared the code and it worked for approx 32 mile and came back on. he said that moisture may have gotten into the knock sensor boot causing the error code or I have a bad sensor. I ...

...knock sensor(s) Locate the sensor ont he side wall of the head. Disconnect the wiring harness and then use a wrench to loosen the sensor. Pull the sensor away from the head and discard. Installation ...