1998 GMC Yukon "time" Questions

how do you set the clock on a 2004 gmc ykon According with the Owners Manual: * Setting the Time for Radios without Radio Data Systems (RDS) Press and hold the HR or MIN arrow for two seconds. Then ...

...you use. If you are going to turn up your timing, make sure you do it with small adjustments at a time starting with 6" and then turning it down every 2" till satisfied with your performance and ...

how do i set the timing on my 96 yukon? what is the correct timing? You cannot,the timing is controlled by the crank sensor and sent to the E C M thus controlled by the electronics,sorry

timing not running good Put a timing light on it and see if the timing jumps arround if so you chain could be bad. You should also put a fuel pressure gauge on it and see what you have for pressure,

Timing 97 yukon I replaced the lower intake manifold gasket on my 97 yukon it starts fine when it is cold but cranks slow when it is hot doesnt the timing adjust itself? distributor has to be ...

car dosnt start up right away have to turn the key at least 2 times some times 3 times before it starts could be ignition switch is no good it will be a lot a work to get a new one in there yourself ...

heater fan will not all the time, after some time it will start and run ok. then the next time after sitting it may run or not, This sounds like your blower motor is seizing. SOUND LIKE FAN MOTOR HAS ...

how do you use an obd2 scanner to time a 1996 gmc yukon. how do you use an obd2 scanner to time a 1996 gmc yukon w/350, and which make and model scanner should i get? It will not time the vehicle,it ...

la la have 2007 yukon xl, go to start it lights are dim, heater fan runs slow, try it a number of times it will start an run, until the next time. computer codes read dead battery, many times, and ...

what is the timing for a 1995 gmc yukon Hello waxx1128, The timing is 0 degrees TDC. Below is the procedure for setting the timing. I hope this helps. Regards, netvan