remove the clip on the brake light switch so that I can replace it. My 1996 Brake light clip needed to spread open with a screw driver(some what like a round spring) and with another screw driver push
...there a tool to remove a spring round clip thats holding the brake switch on a pin to my 99 GMC yukon? If not....What is the best tool and fastest way to remove the clip off the pin? needle nose ...
...pin is held in place with a bolt. Carefully remove this bolt, you may need to spin the carrier to access it, once the bolt is removed (should be an 8mm) you can slide the pin out, and push in on the ...
REMOVE THE PIN) are the spider gears will fall out. Now get someone to push the axel in while you are looking at the 4 small gears in the housing, when they push the axel in a C-clip will fall off the
...the bolt that holds the center diff pin in, then remove pin,AT THIS POINT DO NOT TURN ANYTHING AXLES OR DIFF OR DRIVESHAFT push axle inward and remove u clip that holds shaft in then pull shaft ...
...panel and the heater duct under steering column remove the pushrod retaining clip and slid the brake light switch and pushrod off the pin -remove the 4 nuts slide booster and gasket out from ...
...clip (like a circle "D") that has to be removed/pulled out. Once that's out wiggle the pedal and push the pin out that goes through the pedal and switch. Be careful to remember the sequence of the ...
...pin and then push axle all the way in there will be a c clip on the end of the axle pull that out and remove the axle.Be carefull not to let the spider gears fall out you can put them back but can be ...
Question about GMC Yukon
my 03 sierra 2500 hd hinge pins need replaced. The pins do not have c-clips! How do I remove them? Usually if there are no clips, the pins have to be driven or pressed out. It may be easier to remove ...
Question about Dodge Cars & Trucks
...pin and remove it. Slide the pin out 1/2 way. DO NOT SPIN EITHER AXLE WHILE THE PIN IS OUT. Push the axle in from the outside. You will hear the "c" clip fall in the rear. Put the center pin back in ...
373 questions posted
Usually answered in minutes!
593 Questions
524 Questions
309 Questions
326 Questions
238 Questions