1995 Ford Taurus "focus remove throttle position" Questions

...focus throttle positioning sensor. This sensor keeps you air intake throttle at the proper position when the engine is cold and changes position when the engine has warmed up. to locate the sensor, ...

...focus · The throttle position sensor (TPS) is located on the driver's side of the throttle body · Remove the plastic engine cover to access the throttle body, then locate the TPS. You may be required ...

...focus+idle-air-control-valve.html Here is how to fix it: Unplug the electrical connector on the IAC valve located on the back of the throttle body near the firewall. No tools are needed to unplug the ...

...remove the throttle body or not. I have learned that it is somewhat easier to remove the Throttle Body in order to replace either of these sensors. And there will be less frustration with dropped ...

...Focus Workshop Manual IN-VEHICLE REPAIRProcedure revision date: 07/5/2001 Intake Manifold Special Tool(s)Remover/Installer, hose clamp 412-108 (T96P-18539-A) Removal Release the fuel pressure. For ...

...focus always revs up to about 1500 rpm when first starting the motor and after 10 seconds goes down to about normal 800 rpm - if your car stays very high idle for very long, these 2 items are usually ...

focus se. Car starts fine and runs fine but as soon as you take foot off gas pedal it stops running immediately.Will start back up but same thing.Will stop after lifting foot. its ur idle bypass valve

...remove carbon buildup - otherwise these are fairly inexpensive parts to replace ($25-$45) The idle speed might be set a little low allowing a stall when an engine load occurs like pressing the brake ...

...throttle flap in the intake manifold, or an opening in a gasket. Some of the engines have a part called a manifold runner. This part is like a 2 position shutter. When it sticks, the high speed ...

...throttle position sensor and idle sensor voltages with VOM meter - all OK. Checked fuel perssure - OK. Removed and cleaned throttle body. Removed and cleaned spark plugs. Should I be focusing on fuel ...