...Wrench light went out check light still on. Wrench light, is "Service Engine Soon". Check light indicates there is a stored and current engine computer fault. Often referred to as a DTC,,,Detected ...
check it by having a fresh battery trying to turn the engine over. (I don't have a lot of information from you) If your battery is good, and the starter good, then it is something else. If you suspect
wrench. check this morning on scanner. No codes. What the heck? Electronic's ,go figure .. Not all gliches set code's . Could be any number of thing's - sensor's , modules etc..... A professional Tech
...check light --- wrench, etc) If you do, get the codes & give them to us Could be a coil issue,not a spark plug You change spark plugs at 60,000 miles or every 3 years Change front O2 Sensors at ...
...wrench to avoid damage to the tube. Lower vehicle. Tighten the EGR valve line nut at the EGR valve, and torque to 26-33 ft lb (35-45 Nm). Install the EGR tube and EGR valve vacuum hoses. START the ...
...wrench).Let oil drain.Replace the oil pan drain bolt, tighten ,replace the oil filter( be sure to put a thin layer of oil on the rubber seal of the filter to get a good seal), tighten. Then add ...
...wrench or ratchet and socket. Move the strap away and lower the fuel tank. Discard the fuel tank mounting studs. Unplug the pressure transducer electrical connector located on the top rear corner of ...
...wrench or ratchet and socket. Move the strap away and lower the fuel tank. Discard the fuel tank mounting studs. Step 7 Unplug the pressure transducer electrical connector located on the top rear ...
...wrench is available, tighten to a snug fit and stop. (H) Afterwards, raise the fuel tank enough to attach fuel lines and vapor lines indicated above, item D. After connecting all lines, raise tank ...
371 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
297 Questions
294 Questions