...timing marks on each cam gears one is mark on the middle on the tooth and the other one on the side of the tooth 2001 dodge stratus 2.4 4 door? Click on the following direct Free Link. It has the ...
timing marks are lined up and start putting your belt on the rear cam first that would be 1,3,5 cam. Then route it under the water pump and up around the front cam 2,4,6 cam being careful the rear cam
...timing marks and installed the timing belt, installed compressed automatic tensioner, tightened tensioner cam. Checked tensioner by rotating engine 2 turns then waiting 15 minutes and removed pin in ...
timing marks so that the exhaust camshaft sprocket is a 1 / 2 notch below the intake camshaft sprocket. Use an Allen wrench on the tensioner. Rotate the tensioner counterclockwise while pushing on the
...timing marks on the sprockets.Move the crankshaft to 1 / 2 notch before TDC.Install the timing belt starting at the crankshaft, then around the water pump sprocket, idler pulley, camshaft sprockets, ...
...timing belts on a 2000 Stratus You can get a auto repair manual from the library for instructions. Here are some guides. On a cold engine. 1) Disconnect the battery. 2) Rotate the engine until ...
...timing marks for the timing belt which I went ahead and replaced since I had it off. It was dead on. Well my wife went ahead and drove it for about 2 weeks now and it idles high (1500 rpms or so) and ...
...timing marks are properly aligned, using the recommended procedure. Use care. DO NOT allow oil or solvents to contact the timing belt, as they can deteriorate the rubber and cause tooth skipping. ...
no spark comming from 2 and 3 from the coil just replaced timing belt and now no spark from 2 and 3 but starts and runs off 1 and 4 make sure all timming marks were in the right place
1,399 questions posted
Usually answered in minutes!
1,417 Questions
1,121 Questions
772 Questions
621 Questions
528 Questions