1996 Mazda MPV "causes air lock diesel engine" Questions

...air lock in the cooling system .i am familiar with ford freda and bongo and the design where the engine is is a bit far from the radiator ,so the problem with air locks magnifies.really the solution ...

to rise. Engine Head gasket changed but problem persist. REMOVE RAD CAP AND RUN ENGINE AT 3000RPM WITH ALL HEATERS ON SOUNDS LIKE AIR LOCK, ALSO CHECK IF HOSES ARE HOT Have you replaced the thermostat

...good luck it could be the high pressure oil pump for the fuel system or a faulty fuel injector that allows air into the fuel system causing an air lock in the fuel rail. sounds like a stuck egr ...

...air lock in fuel system? if it runs after using easy start there is no air in the system. There will b e a problem with the tips of the injectors and they will need replacing. Cranking speed is ...

...crank after replacing engine won't run after replacing fuel modulator did you prime the filter and get the air out of the lines if you dont it will cause a pressure lock and not let the truck

...lock that is in the fuel lines. Some mechanics add fuel to the new filter to remove some of the air and promote fuel draw. The O rings on the injector lines are a special type which resists petroleum ...

...air and ruin the fluid. Hi, I've about the same problem on a '03 passat diesel. I'm about to check out the problem and found that a lot of water is trapped in the air intake plenum as the drain holes ...

...air lock as it starts but doesnt keep running? i had to click on 2006 peugeot 405 as it wouldnt let me select a product. my car is infact a 1996 406 406 1996 Diesel would either be 1.9D, 1.9TD or ...

...air-flow meter and idle control electronics. Later 3-litre Turbo-diesel can run perfectly or bring a nightmare sequence of problems. Alloy heads can crack. Major recall for 1998-2000 models involved ...

...air compression and the glow plugs work fine, it hits off of ether* Any tips? Possible solution. I have an Edge Juice Programmer for my '04 6.0. While making the harness connections, I misjudged one ...