...ignition control module part of the distributor? Hi, common thing with the mazda was the coil or the ignition amplifier going faulty, both of which are located within the distributor, the coil ...
...ignition control module gone out or a coil. They get hot and quit working after a short period of time, cool off then work again till they get hot. Is the ignition system pointless electronic or does ...
...ignition switch and/or ECM for power. You have power at the pump, check the ground and make sure it is connected properly. Will the pump run when someone turns the key on? Pump runs, check fuel ...
ignition is 'on'. Start the engine, and allow it to run sometime. Then check the reading on the dashboard. Measure the coolant temperature with a temperature-tester. This will let you know whether the
Question about Mazda 626
ignition control module it has 3 electrical plug-in sockets but I only have 2 plugs in. Is there supposed to be 3? Question edited for clarity and spelling 'module'.. Question moved to model category.
...ignition signal from the Powertrain Control Module (PCM) or Electronic Control Module(ECM) is sent to and amplified by the power transistor. The power transistor turns ON and OFF the ignition coil ...
...ignition control module by pressing down on the locking tab where it is stamped PUSH, and remove the connector. Remove the ignition module and the module bracket from the front fender apron. Unfasten ...
Question about Cars & Trucks
...ignition control module ground to ensure that it is clean and tight. If there is no problem found after performing the suggestions above and the SI diagnostics lead to ignition module replacement, ...
...ignition signal from the Powertrain Control Module (PCM) or Electronic Control Module(ECM) is sent to and amplified by the power transistor. The power transistor turns ON and OFF the ignition coil ...
Question about GMC Cars & Trucks
...control modules B+, ignition, ground, communication enable and serial data circuit terminals Determine the module that is not communicating. Refer to Control Module U Code List. Ignition OFF, ...
302 questions posted
Usually answered in minutes!
544 Questions
410 Questions
356 Questions
269 Questions
277 Questions