...and repair You need a heavy press to replace the bearing so they can be done at home. Remove the carrier from the banjo housing and have a machine shop replace the pinion bearings and carriers ...
assembly. You can drive the bearing race out from the inside by removing the carrier and the pinion gear. Carrier bolts need to be torqued. (don't remember the # off hand but it's in any decent manual
...carrier bearing or a bad U joint too. Isolate it by dropping the drive shaft and turning the pinion yoke by hand. If there is a problem, you'll be able it feel it. Then look at the drive shaft for ...
bearing caps on at either side of the carrier. Pry the carrier out with a pry bar or two, and be sure to catch the shims that live outboard of the bearings on both sides. You (or whoever is doing this
...as to what it may be? Well if the roar is coming from either the left or the right side its a wheel bearing.If its more to center of the truck it can be a pinion bearing or carrier
...a bent or damaged wheel. Check your front CV joints and axles. Check front wheel bearings. Check for slack in your pitman and idler arms. Check the ujoints and carrier bearing on your rear
...carrier bearing, or center bearing. If that crossmember is bent, and bearing is out of alignment, it could cause unwanted stress on shaft, so don't drive it if you can help it, until it's fixed, and ...
...rotor and might not notice the at highway speeds,if not your brakes check your u-joints and/or carrier ...
Question about GMC Sierra
...bearings The Posi Clutches Or you ran it out of fluid from a leak, in which case you install new carrier bearings & clutches If it could do that at 19 with no experience or help 48 years ago ...
942 questions posted
Usually answered in minutes!
987 Questions
847 Questions
676 Questions
604 Questions
457 Questions