2003 Ford Mustang "brake light fuse keeps melting" Questions

...light and fuse. The fuse keep blown. What can be causing the fuse to blow? a short in the system You have a power feed shorting to ground causing the fuse to melt. Unplug both brake lights and have ...

...brake light bulbs and see if the contacts inside are bent and touching this can cause a short, you can check the brake switch above the brake peddel see if any of the wires are melted together hope ...

...brake lights,parking lights and blinkers arent working and when i try to replace the fuse,it blows immediatly. what could the problem be? the night before,the horn went off in the middle of the night ...

...bulb sockets is shorted out. I have seen bulbs almost melted in their sockets, on grand cherokees in the past. You will have to check all the brake light and bulb sockets to see if they are

...brake light socket keeps melting the bulb where it connects, after replacing the bulb several times it wont work at all. also everytime i try to use my cigarette lighter it wont work and it pops the ...

...brake light fuse keeps popping. Also we started it last night and wire harness caught on fire. The wires are not bare and some of the harness is melted. hi, your either going to have to either get a ...

brake light failure checked fuses,replace bulbs,checked wiring for damage /corrosion brake pedal switch cleaned , proven to be working.originally drivers side was not working replaced both bulbs now ...

...light is on unless you push brakes, blower moter fan only blows on 4, when fuse blows cannot take out of park unless we use the manual release beside the gear shifter. Could this all be related to a ...

light fuse kept on blowing so i looked at my switch wires and they were melted so i bought the 400 dollar switch from gm and my lights worked for another week started blowing fuses again now they wont

...brake lights were on and it was determined to be a problem in the gear shift, good luck! The engine thermostat is plastic and melted off causing fluids to get into the pistons. We argued and argued ...