2000 Ford Mustang "v6 plug wire" Questions

ignition coil pack wire order for a 4.0 v6 mustang 2006 model i changed plugs and plug wires in my 2006 mustang 4.0 v6 now it is flooding and wont idle 1-4-2-5-3-6

...V6 sputters It only happens when is raining or I drive in the snow. That sounds like bad plug wires or ground. Performance plug wires are cheap enough to try. There won't always be a physical break ...

put on new plugs and wires and now it spits and sputters, backfires. When change them went plug and wire in order I would recheck them. Check the codes. This will tell you which were crossed.

V6. if you haven't try getting new dis cap and coil wont hurt to replace anyways and a plug wire will arc off other plug wires and cause miss fire may try replacing wires as well.Hope this helps, Good

...v6 sohc and car runs rough like its missing. changed spark plug wires and still bogs down. cheaked cylender order and conections and every thing is right. yellow engine light came on at first but i ...

94 mustang 3.8 v6 need wiring diagram for spark plugs don coil pack to spark plugs Here's a picture for you. I hope this helps and good luck.

...v6, when i bought the car it had a slite misfire,i bought a new coil pack, changed the plugs and wires, I hooked up the coed reader and it pulled up P0302. cylinder number 2 missfire,i pulled the ...

...V6 starts, idles, check engine light is off, misses on throttle up? checked all sensors, fuel filters. Question symptoms of clogged exhaust and diagnosis. CHECK FOR OVER FILLED OIL LEVEL,DAMAGED ...

...plug For the 2000 Ford Mustang: Based on your question you should have the 3.8L V6 and not the 4.6L SOHC or DOHC V8; however I have included all below. For the 3.8L V6: Firing Order: 1-4-2-5-3-6 ...

...v6 new plugs,new wires,and new ignition coil still will not run smooth.also the left bank is not heating up.obd2 said it was number 4 wire ? Could have one or more bad injectors, another electrical ...