2000 Ford Expedition "remove back windshield wiper arm" Questions

Ad

Question about Ford Expedition

2 Answers

...Remove the screws holding the rear wiper motor to the inside of the vehicle at the base of the rear window. Pull the rear wiper motor off. Install the new wiper motor and put the wiper motor and arm ...

Ad

Question about Ford Expedition

2 Answers

...back on to the ball stud. If the shaft that is installed onto the motor is spinning but not moving the rod the motor must be replaced. Oopen hood and remove three bolts holding the motor to the ...

Ad

...remove the windshield wiper assembly on a ford excursion from the shaft that moves the wiper back and forth? Wiper Pivot Arm Removal and Installation Lift the windshield wiper pivot arm to the full ...

Question about Ford Expedition

1 Answer

...back and forth to loosen them from the pivot shaft. Lift off windshield wiper pivot arms . Remove seven screws retaining the cowl top vent panel. Disconnect windshield washer hose (17A605) at LH side ...

back until the hinge locks in a verticle position. remove the retaining nut at the bottom of the windshield wiper arm and pull the wiper arm off. slide the new wiper assembly on. tighten the retaining

Question about Ford Expedition

4 Answers

...remove the wiper arms, wiper linkage and wiper motor from the wiper motor bracket, and install a new bracket. I just bent the tab back into place a couple times for our daughters 2005 Impala but it ...

...back until the hinge locks in a vertical position. 2. Remove the retaining nut at the base of the windshield wiper arm and pull the wiper arm off. 3. Slide the new wiper arm assembly on. 4. Tighten ...

...windshield no problem, but the passenger side wiper got stuck half way, went back down to the rest position and now it will not work at all. sounds like the connecting rod between both wiper arms ...

...back together and it's fine for a week to a month, then the whole ordeal starts all over. So I figure I'm gonna solve the problem by taking the grill between the hood and windshield off and cleaning ...

Question about Ford Expedition

2 Answers

...remove the nut, mark the arm and the shaft or top of the mounting area so you know where to place the arm back on the splines. Then, you use a tool similar to a battery clamp remover and pop the arm ...

Not finding what you are looking for?
2000 Ford Expedition Logo

3,327 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

1999 Ford Expedition
1999 Ford Expedition

1,825 Questions

1998 Ford Expedition
1998 Ford Expedition

1,627 Questions

2003 Ford Expedition
2003 Ford Expedition

1,696 Questions

2001 Ford Expedition
2001 Ford Expedition

1,161 Questions

1997 Ford Expedition
1997 Ford Expedition

1,048 Questions

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...