...motor mount and see whether the mount is flush or has protruding studs. Flush shaped will be easier to handle. An 1/4 inch of clearance would allow you to slide parts through the opening. You could ...
...change my oil pan on my 2000 ford crown victoria. There seems to be a welded in crossmember holding the engine underneath do i have to remove the motor mounts and raise the engine to do the oil pan ...
...change and the volt gauge doesnt fluctuate at all thanx Scott Check battery connections for corossion. Also check battery to body ground, battery to motor ground, and motor to body ground strap for ...
degrees. Don't hear it in the winter at all. It sounds exactly like you are on a rumble strip. Have changed tires, bearings, brakes, turned rotors, and joints. No one seems to be able to find anything
...change the pan? OK then, consider the sump, is it front or rear? Do you have room to drop the pan 6 inches and get it out? The oil sump is at the bottom of the pan. If not, you have to pull the motor ...
...change a power window motor on a 2003 Crown Victoria? remove the door panel. be very careful and make sure you get all the screws out. Should be maybe 2 on the bottom half of the door, and 2 on the ...
...change spark plugs and coil connector wires on 2000 Ford Crown Victoria with 4.6 engine. First time on this type of system. Each coil mounts on top of the spark plug and is bolted down to the intake ...
...and on your car it happens at that point. If it has been awhile, get the Autotrans filter and fluid changed. Do not mention the vibration. If there is excessive metal chips in the trans pan they will ...
...change going from auto to manual.. I can still control where the air blows but have lost most of the control over the fan speed. My name is Ron,and I will try to assist you.There is a blower motor ...
453 questions posted
Usually answered in minutes!
454 Questions
486 Questions
323 Questions
294 Questions
301 Questions