...lights on, replace the switch. If the light do not come on by jumping the connecter, you will have to trace the wiring to see where it is broken. If the pink wire is hot with the key on, the break in ...
...lights,drk Pin Wire Color Circuit No. Function A BRN 9 Parklamp Feed B LT GRN 24 Backup Lamp Feed C BLK 750 Ground brn tail lights turn parking lights on & with a test light back probe connector ...
Question about Pontiac Grand Am
...wire at head lamp is voltage, headlamp switch on. The bottom wires are ground. Your headlamp switch/dimmer are part of the ground circuit for headlamps. You might be able to use redundant ground with ...
...lights flashing or just one side? Visually inspect the connector for bent pins and the harness for bare or frayed wires...If you have a multimeter and a wee bit of experience using it; Set the ohm ...
switch housings. This screw is underneath each housing. Once removed, there are dash mounting screws behind them. These screws (and many of the other dash screws) are a smaller torx-bit (T-10 or T-15,
lights when a door is opened by the BCM grounding CKT 156. When the switch is in the ON position, ground is supplied through CKT 750. The rear view mirror reading lamps are controlled by the rear view
...switch on as well. If you have power on only one side of the fuse, the fuse is blown and replacing it should get your lights working. However it may blow again as there might be a short. If you have ...
...lights work fine. the light switch controls all the light in different terminals must likely your light switch is diffective I hope this information is useful good luck if the fuses are all good then ...
WIRE- REMOVE IT- LOWER COLM. AND HALF WAH DOWN ON THE TOP SIDE IS THE SWITCH FOR THE FOG LAMP CONTROL IF YOU HAVE ALREADY REPLACED THE ELEC. SWITCH - (PUSH BUTTON OR ROCKER STYLE ).IN THE DASH. IF - -
361 questions posted
Usually answered in minutes!
1,771 Questions
1,538 Questions
1,504 Questions
1,435 Questions
1,208 Questions