1993 Pontiac Grand Am "small engine ignition switch wiring" Questions

on top of the starter). Connect power to the small wire on it for a second. Any results? Use a screwdriver to bridge the two large connection bolts on the end for a second. Sparks and engine turn over

engine just does nothing. i had no warning lights...nothing to say something was wrong. The most common problem here would be a bad starter, you can test it with a test light,have someone hold the key

...engine compartment. I is a small bulb unlike the hole light as in older cars. You must pull the plug connector off the back of the bulb than un-clip the heavy wire spring retainer and pull the bulb ...

...engine (Intake area) and the main ground connection is very important so you'll want to inspect that area as well. Sandpaper/emery cloth can be used to prepare the mounting surfaces if any rust or ...

small 4 cyl. I hooked up jumper cables and engine started cranking, no key in ignition. I had installed a new starter, battery and solenoid relay on the fender well 2 months prior. About 2 years ago I

...engine will start with key on and use of remote starter switch. starts then shuts off you will need to replace the ignition switch. the wires running from switch have broken very small wires. common ...

...engine starts but then dies after about 5 seconds if there is a coil on that model bring small wire from positive on battery to positive side of coil and see does it keep running ,if it does check ...

What is the small wire on the starter for Ignition switch. That is the wire from the ignition switch that engages the starter solenoid to crank the engine over so it will start running.

to the ignition so he can crank it up? Drop the column and remove the ignition switch (on top of column) with wires attached, You can slide the mechanism using a small screwdriver and start the engine

...small connector the starter should crank engine. If this happens then starter is OK and the problem is in the ignition or the relay. But if it does not crank then the problem is in the solenoid which ...