motor mounts enough to push the motor forward. Just about an inch is all I did and no problems after when I put the transmission back in. Don't forget to remove the drive shaft first, and you must not
Question about Nissan Pathfinder
...motor, fuse, and possible ground problems, and sent me away without fixing the problem. They mentioned the BMC and that I would have to go to the dealer to fix it. the switch that you turn to ge the ...
Question about Nissan Pathfinder
...be a problem with either the control module in that door, or the switch, or the door mounted window motor. It will be a process of elimination, starting with whether one or all windows don't work. No ...
...can i try without going to a shop? Plugs, wires,check for vacume leaks. you might check your motor mounts by putting vehicle in forward and reverse with foot on the brake while giving it a little ...
...wire going in and said it was only 2.4 volts ? I am thinking that this is not enough to fire the motor. I spoke to the dealer today and they said there isn't a resistor since the vehicle has AUTO
Question about Nissan Pathfinder
...voltage at the starter solenoid (small Black Wire with White stripe ) You have to unbolt the right motor mount and jack the engine up to remove the starter. test so that starter is last resort. Hit ...
Question about Nissan Pathfinder
...on your starter. Sometimes the solenoid freezes up and won't allow the power to start the starter motor spinning. So, this helps that and allows for the inductive current to pass to the starter ...
...control linkage from selector lever. (2WD model) Disconnect A/T harness connectors. Remove starter motor. Remove gusset securing engine to A/T assembly. (VG3OE engine model)Removal: - 4WD and 2WD ...
...motor mounts on my daughter's Kia Rio Cinco (2002), but can't find a repair manual for the car. I've done motor mounts in other cars and they were easy. Any idea if there are any potential problems ...
motor mounts to make sure the bolts are tight, then i would check the rear transmission mount bolts, also to make sure they are tight. yes , if the bolts mounted to the tranny need to be replaced, you
626 questions posted
Usually answered in minutes!
716 Questions
599 Questions
586 Questions
405 Questions
314 Questions