2003 Mazda Protege "change 2 map light" Questions

...2 weeks not knowing what the heck was wrong with my car after I had it at the Mazda service department for an oil smell which my husband fixed by tightening the screws. Apparently the mechanic leaned ...

...2-500 rpm with no change in acceleration. Tried running without air filter, ran the same, thought I would try the MAP sensor, just disconnected it and tried to start van, wouldn't do anything, ...

MAP SENSOR AND THAT IT WAS OK, ONLY EGR VALVE CODE WAS CAUSING LIGHT ON AND THAT WASN'T MUCH OF THE PROBLEM. ALSO I WAS DRIVING CAR FOR 2 YRS WIHTOUT EGR VALVE ATTACHED TO THE CAR-HIM OR HIS MECHANICS

...map censor and cy 2 misfire ok we put new map censor and new coil pack on 2 it ran great for like 10 min started doing it again we went back had it scand again it moved to cy 3 misfire the part store ...

...2.5 Volts (indicating partial throttle) does the MAP sensor indicate a reading that isn't at either extreme? Using the Freeze Frame data (if available) compare the MAP reading to the TPS when the ...

...2.5 Volts (indicating partial throttle) does the MAP sensor indicate a reading that isn't at either extreme? Using the Freeze Frame data (if available) compare the MAP reading to the TPS when the ...

...2) sensor. What is this? My car sometimes does not start up and dies after turning the ingination. Now it is turning off while I am driving. Is this hard to replace? If no, where is the part located ...

...2. If there are no restrictions, and the value doesn't change with vacuum, then perform the following: with the Key on and engine off and the MAP sensor unplugged, check for 5 Volts at the reference ...

2 days d before I changed my catalyst converter it started to die and changes gears rough and sounds ugly when i put it in drive from park. It is still dying when i stop at stop signs and lights whats

...map-sensor-2 do not use my numbers as verbatim, get your own FSM and see the chart for your sensor on your engine. keep in mind the ECU provides the ground to this sensor. so measure ground on the ...