...blend door cannot reach desired position. possible failure at evaporator assembly or wiring to blend door actuator. E7 - blend door cannot calibrate. possible failure at evaporator assembly or wiring ...
...blend door actuator not working properly. replaced actuator, when plugged in before installing actuator runs constantly. Is the problem in the control board or in the dash? Hello: I have bad news for ...
...blend door I am having the exact same problem. After turning the ignition to off and restarting the vehicle, the A/C works properly again...for a little while. Is it really the actuator or something ...
Question about GMC Yukon
...blend door actuator I located two blend doors but not sure witch one opens the front vent, air only will come out on the floor and defrost. Can anyone help? Hi Chris, I had a similar problem with my ...
blend door or control module? 2016 jeep compass my amber light flashes on the defrost knob I have no air when this is happening. When it stops everything works just fine I open the driver's door and I
...blend door a new heater core and still have no heat. it iwll blow hot and then start blowing cold air after about 3-5 seconds. I was told the acuator may need to be callibrated to my computer is this ...
...blowing cold air is this a control sensor or a temp. sensor that could cause this problem manual temp control? or auto temp, its either out of calibration or the blend door actuator or door is ...
...blend door located on a 2004 trail blazer Does it have manual or automatic climate control ? manual or automatic has two temp blend door actuators - driver side & passenger side . Video's on ...
...Blend door actuator feedback failure (bad servo) 24: Mode door actuator feedback failure (bad servo) 25: Ambient temp sensor failure 26: ATC In Car thermister failure (ATC only, bad ATC head or ATC ...
Question about Cars & Trucks
...blend door is closed all the way towards the back of carinterior arm is not on door or actuator will it adj. it self? When replacing a door actuator you must perform a re-calibration. To do that you ...
907 questions posted
Usually answered in minutes!
593 Questions
309 Questions
326 Questions
238 Questions
255 Questions