1992 GMC Sierra K1500 "ignition" Questions

...battery is good and the engine will crank over, then it sounds like a faulty control module. The ignition module located inside of the distributor is what generates the signal that the ECM (Engine ...

ignition not firing won't start Do you have fuel, is your fuel pump working. If you do not have any spark at all, have you been able to check to see if you have power to your distributor. If so and ...

1992 GMC K1500, 5.7L has no spark. New battery and ignition coil. Is parked on a slope headed downhill towards the driver side. Remove the distributor cap while cranking, see if the rotor turn. If not

ignition is bad I need to replace the ignition in my 1989 GMC k1500. I do not know how to remove the old one. I pulled the steering wheel off but can't seem to get the ignition out. Remove the 3 ...

...where to go next Check your fuses (ECM) and also recheck your wire leads to the coil. Your ICM (ignition control Module) may also be bad, it's located in your distributor under the rotor. You can ...

ignition tumbler is noy ingaging 1979 GMC 1/2 ignition tumbler is not ingaging 1979 GMC 1/2 ton 4x4 the tumblers are jambed any locksmith will advise to replace the lock cylinder for the part is ...

...1989 GMC 1500 4X4 The distributor does have to be removed and dis-assembled in order to replace the ignition pick-up coil/stator, and if the pick-up coil/stator is faulty then the distributor should ...

Slow Turn on Ignition I have this truck and when I click the ignition it seems to drag to start, but yet starts right up. Initially gives me impression battery is bad. We're only talking a few seconds

...the key nothing happens also has new battery check for power at starter and also check for power on ignition wire on starter selonoid while ignition is turned to start position. be cautious as it ...

...inside the vehicle and depress the clutch to shift the car into "Neutral." Insert the key into the ignition and turn it to the "On" position. This is the place the key would be after a normal turn