1998 Pontiac Sunfire "install cylinder head temp sensor" Questions

...install in the car as we figure it's a a short in the wire. Our next step is to take it to the dealer if we can't fix it with replacing the wire. Thanks Ensure you are checking the right sensor. The ...

cylinder head temperature sensor located on a 2007 Ford Fusion sel 3.0L v6 https://www.yourmechanic.com/question/i-m-trying-to-replace-the-engine-coolant-temp-sensor-on-my-2007-ford-fusion-sel-3-0l-v6

...Cylinder Head Over Temperature Protection Active Description: Indicates an engine overheat condition was detected by the cylinder head temperature (CHT) sensor. An FMEM strategy called fail-safe ...

WHERE IS COOLANT TEMPERATURE SENSOR the engine coolant temp is installed in the engine coolant passage of the cylinder head

...each cylinder cranking the vehicle (with ignition disabled) and observing the gauge. Each cylinder reading should be significantly close to its next one. If not, suspect a faulty cylinder head

cylinder head. To Install: Clean the threads in the sensor mounting hole. Apply sealer P/N 13246004 or equivalent to the threads of the sensor. Install the sensor and tighten 15 ft-lb (20 Nm). Connect

cylinder head, at the cruise control servo bracket. It is necessary to drain coolant from the cooling system to a level below the sensor, prior to sensor removal. Disconnect the negative battery cable

install a coolant temp sensor in a 1995 ford escort 1995 ford escort coolant temp sensor replacement The coolant temperature switch and fan control switch are located sie by side, mounted in the steel

cylinder head temp sensor,why is temp gauge still going all the way to hot? with sensor disconnected gauge reads midway.when i connect the sensor needle pegs hot regardless if engine is running or not

...circlip. Remove the ECT sensor by pulling out from cylinder head. Extract also old "O-ring" sealing rubber. Install new ECT sensor with new "O-ring" sealing rubber. Please rate my response.