...engine front cover case, have to remove crankshaft pulley and other stuff,water punp pulley belts
Question about Nissan Sentra
Where is the starter located? I have removed the air intake and battery etc. I still do not see a starter! Follow the heavy wire from the "+" terminal of the battery. It will lead to the starter.
...location? rpm in my car (nissan sunny mod 1996) si too low, replace spark plug, cables, etc, sensors its ok, but rpm still low. Tank you very much The idle speed is computer controled, it is not ...
...at the pulley and locate this mark. once found using a paint pen in a bright colour (red, white etc) colour the mark so it is more visable, then timing the engine should be easy. If there is ...
...assembly. the part is no more than 40 dollars. go under and find it check for poor connections etc first but 80% its the switch gone bad. its not closing the circuit when the pedal comes to
sensor can be replaced alone, how do I do that? Where is it under the hood, what tools will I need, etc.? yes cam sensor is located in the distributor best way is to replace distributor .you will need
...etc.). Just write your questions like below; How to replace 2001 Nissan Sentra starter location? then you'll find a lot of answers. See the below RH side of the pic is the starter. See; this site, ...
...just inside the car engine compartment that turns the AC unit compressor pully , the alternator, etc.it is connected to the crankshaft pully.. If you have a front wheel drive it is located on the ...
...the bearing. You may have to take it to a service shop. Call around. Depending on your location you have Sears, PEP Boys, VIP, etc. Avoid driving on the bad bearing, it can cause further
and to the right of those is another round dial to select air flow (foot level, windshield defrost, etc.) Hope this helps
1,007 questions posted
Usually answered in minutes!
798 Questions
716 Questions
570 Questions
508 Questions
442 Questions