1993 Nissan Pickup "timing marks ignition set" Questions

timing lamp, but I don't know the right mark, it says 10 degrees BTDC. The pulley has 6 marks, which one is the right one? the mark to the right of the pully will be 0 .. it will be like this. 8 6 4 2

ignition timing on a dodge truck with a 318 motor year is 2001 hook up to timing light, start vehicle. loosen distributor hold down bolt. aim timing light at timing mark. rotate distributor either way

...timing marks. 1995 Nissan Hardbody XE Shortbed. 4 cylinder, 2wd, 5 speed. I would like to set the ignition timing on my truck. The marks on the driveshaft pully are not hard to find, but I can't find ...

...timing marks. Make sure you can see the mark in the flash of the light. You want to wait 5 or 10 minutes after starting the vehicle to allow it to warm up, make sure you have the Heater and AC turned ...

...timing marks on cam timing in correct position, no 1 cam lobes should be "rocking" and no4 cylinder should be at top dead firing stroke(ignition)should be notch in dissy when cap is off or set so ...

marks with the marker on the timing case cover and set the contact breakers at the point of opening at 8 degrees BTDC. The use of a 12volt bulb with two cables. Ground one and connect the other to the

...you heed a timing light and the engine running, then you use the timing marks on the pulley and the front case to set the distributor to the correct number of degrees before TDC as per the

...ignition lead . On the timing chain sprockets there will be a mark on each that align or point to each other and u fit as such. As long as u make sure your on no 1 cylinder compression stroke and cyl ...

...timing light and observe the position of your crankshaft mark as you increase the engine rpm. You should see the crankshaft pulley mark move in relation to your marks on the engine block. If it does ...

...timing marks if they are aligned. If the distributor has been moved all the way on either side, you may have to have the distributor moved. Also check the ignitor. It may have gone bad. Other than ...