I have an Isuzu KB260 4x4 On how many degrees before TDC should the timing be. isuzu engines has timing marks. normally the piston #1 is set at TDC then the camshaft sprockets marks must match up the ...
...everything runs good except idles very rough. checked timing three times with a jumper wire at 5 degrees BTDC and rechecked with jumper wire off at 12 degrees BTDC. also checked for vacumm leaks ...
...degree mark once, until it comes back again (the second time) both marks on the cams need to match up exactly the way they started... next set a inductive timing light to number one cylinder, and gap ...
Question about Nissan Pickup
...pickup 2.4l fuel injection. I have the timing lamp, but I don't know the right mark, it says 10 degrees BTDC. The pulley has 6 marks, which one is the right one? the mark to the right of the
...at the terminal (I know the last two should be the same) THE ROTOR, THE TIMING MARK CAN BE 180 DEGREES
...the other day did it step by step it fired up but the timing was off and it only could go to 20 degrees from right to left the factory spec of course is 10 degrees but it could even reach
...is also new. the truck will not start it has gas and fire what am i doing wrong Sounds 180 degrees out. Move flywheel to top dead center. Remove timing belt and turn flywheel pulley ONE ...
...gear (crankshaft) which should be at 12 o clock position. on the camshaft there may be 2 marks 180 degrees apart from each other. number 1 cylinder is on the passenger side front, remove the ...
what are the timing marks on a 1997 nissan xe your nissan's timing is 10 Degrees from tdc G
...degree mark is tdc for a 22r engine? -You replace timing belt and want to line up...? If so must be 0 (Zero) -Or just want to adjust timing...? If so check under the hoop. It should has label there ...
453 questions posted
Usually answered in minutes!
829 Questions
564 Questions
428 Questions
367 Questions
319 Questions
